Reolink Year in Review 2023 Learn More
Unveiling the New Standard in Clarity With #Reolink16MP Series Learn More
Reolink App v4.44 Released Learn More
Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.
Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).
I recently bought the 8CH PoE NVR with three RLC-422-P dome cameras, and one Reolink RLC-423.Before installing everything, I felt it best to test each camera, and good thing, too, because nothing works as advertised. The NVR boots up to the Setup Wizard, and allows me to enter a p[censored]word, but the "Next" [censored]on is dim, and won't let me past that screen. I can see the edges of the camera image behind the setup wizard, but can't get p[censored]ed the wizard. The HDD light is orange/red and blinking, so I [censored]umed that maybe it's downloading from the internet, so I let stay connected for roughly 30 minutes, and nothing. I've unplugged the power to the NVR, waited a few seconds, then plugged it back in.Any thoughts?I hope this is just a minor glitch, and not indicative of the system overall. I can't even get p[censored]ed a log in screen? Seriously....
Hi, please kindly check the P[censored]word and Confirm P[censored]word you input are the same in the Setup Wizard.And the HDD light means it is recording.
The p[censored]word and confirm p[censored]words were identical, I have no doubt about that. I wasn't the only one entering it. I had a buddy enter it as well, same result. That wasn't the issue. I unplugged it, let it sit overnight, and plugged it in again, used the SAME p[censored]word (it's the same one I used for years, is "complex" but not difficult) and it let me in. I'm a little wary at this point that perhaps I've got a defective DVR. Nothing was changed, other than unplugging it over night.
Welcome Back!
Hi there! Join the Commnunity to get all the latest news, tips and more!