@joseph_1979 hi, no positive change with static as well. Two cameras kept on working and third one went offline

NVR firmware, as per the reolink support website, I have the latest one. Unless there is one that is not related on the website to download for public.

@joseph_1979 the cameras which are working are getting the following up assigned: 172.16.25.x



I tested without the LAN plugged in and same issue. 3/8 cameras are working and when restarting the NVR the 3rd camera goes offline and gets swapped with one of the non working cameras...

Also, any concern regarding this:

Cameras (d800) are on firmware: v3.1.0.802_220110003 but as per the firmware section, latest version is v3.0.0.183_21012801

@joseph_1979
Hi, the color code in which ethernet cable is crimped would make a difference? I didn't followed the T-568B standard.. I just crimped same color pairs on both end..

Kit: RLK16-800d

Nvr updated to latest firmware: v3.3.0.226_23031621
Cameras (d800) are on firmware: v3.1.0.802_220110003 but as per the firmware section, latest version is v3.0.0.183_21012801

Issue: only 2 or 3 cameras are showing up on the nvr. Rest do not show up at all... Out of 3 camera showing, 2 stay constant and other one keeps changing to one of the other 8 cameras. All cameras are plugged in directly to NVR and NVR LAN is plugged into ethernet from router. Have tried resetting cameras one by one. Once reset, additioanl two start to work for sometime and after NVR reboot, cameras are gone again.