This problem occurred prior to my installing the beta firmware. The beta firmware has not corrected the issue.

At present, if the RLC-823A is placed in patrol mode it will perform a 360 pan as it moves from one mark to the next. Request an option to set the left and right limit of the panning area. This would allow the patrol function to be limited to a specific region and prevent the camera from panning across the area where it is attached to the wall.

Has anyone else experienced issues with the RLC-823A not wanting to pan up to its horizontal limit? When I installed the camera it worked correctly, 2 days later and the camera will no longer pan to its upper most limit. This creates a problem when zooming in, the angle forces the view to focus on a spot on the ground other than the intended location. Any suggestions?