I mounted and installed an E1 Outdoor today. Runs smoothly so far, but condensation forms on the inside of the lens. I took it in, immediately the condensation was gone. Now she's out again, and sometimes it's good, sometimes it's bad. What can you do? I once wrote to the support, but on the net it is often said that you should wait until this is regulated. But shouldn't such a camera be delivered as dry as possible?

I think that you can read this post to solve this condensation. Here: https://www.reddit.com/r/reolinkcam/comments/lqglqp/ geometry dash subzero avoid_reolinks_new_e1_outdoor_camera_moisture/Condensation