New to the E1 Pro
HW No. IPC_566sd....
Firmware: 3.1.0.3149...
(would have been cool to just copy and paste that out of the reolink app on my Mac.)

Finding a number of enjoyable features for this camera. Is there a setting where we can define the filename of the recordings?? CamName-Start-Endtime.mp4 seems ok for 1 day. What about tomorrow?

Have put a 2nd camera in there and replaced the memory card with a brand new one. Still reboots when something comes on screen to record.

Not sure how moisture would get into the reset button plus it has been up for a few days and would assume that would have dried. Also set it up in the lab and not getting this problem.

What else might be affecting it?? Seems to happen when something needs to be recorded.

Are there any logs I can access to see if it can tell me what is wrong??

Our E1 Pro indoor cam keeps acting like it is powering on and spins moving the lens then coming back to our viewing position. Sitting in the room with it, this happened 4-6 times in 20 minutes. Not sure how troubleshoot this or what is causing it. The firmware is updated, tried power on/off and disconnect power and reattach. We have the app on 4 devices to watch the feed and each app is connected to the static IP of the camera. The reboot thing only seems to do this during times of recording and not during still times. Can't seem to find logs to tell me what was happening at the time.
Any suggestions?

New to the E1 Pro
HW No. IPC_566sd....
Firmware: 3.1.0.3149...
(would have been cool to just copy and paste that out of the reolink app on my Mac.)

Finding a number of enjoyable features for this camera. Is there a setting where we can define the filename of the recordings?? CamName-Start-Endtime.mp4 seems ok for 1 day. What about tomorrow?