Navigation

    Community
     reolink reolink  reolink reolink
    • Search
    • Store
    • Community
    • Support
    • Register
    • Login

    Unable to connect one of my cameras to existing cable.

    Discussion About Products
    2
    2
    12
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • cleighton3373_355664956465289
      cleighton3373 last edited by

      Afternoon everyone,
      I purchased the following system which arrived yesterday- Reolink 5MP HD PoE Security Camera System 8CH NVR 24/7 Recording K8-520B2D2-5MP. it's a new build house and most of the cables were installed during first fix. Out of the box and cameras installed within a few hours. I am unable to get one of the cameras working, I have tested the cable using a network cable tester and all the lights are synched. I tested the camera using a patch cable to the NVR and it's fine.
      The two RLC 522 cameras have fogged up internally, but I have emailed reolink support in relation to these.
      Does anyone have any suggestions?
      Thanks

      1 Reply Last reply Reply Quote 0
      • Cynthia_124785627824270
        Cynthia last edited by

        Please exchange the cable and the port to have a try. You can also reset the camera.
        If you have a monitor that is connected to the NVR, please go to the IP channel to check the status of that camera. Is it offline or connection failed, or something else?

        1 Reply Last reply Reply Quote 0
        • 1 / 1
        • First post
          Last post
        Reolink cloud reolink reolink Reolink cloud reolink reolink

        Reolink Store|Support|About Us|Privacy Policy|Terms and Conditions

        Copyright 2021 © Reolink All Rights Reserved.