Navigation

    Community
     reolink reolink  reolink reolink
    • Search
    • Store
    • Community
    • Support
    • Register
    • Login

    Add a option to send a trigger to camera to start recording.

    Discussion About Products
    1
    1
    9
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • suto norbert_51454295699656
      suto norbert last edited by

      Hello there,

      Please add a option to send a signal to camera (Argus 2, with solar panel) to start recording. I read a lot of, that you dont want to enable RTSP or any third party software. I understand, But, it would be great that we able to send a trigger, to start a recording. I think it enought that we set the official time (8, 15, 30 sec) to record.

      It would be great that it is a "cross platform" solution (a little api, or a web based thing etc..)

      If you think that is "to risky" (it decrease battery...) you able to create limitations (like it accept trigger only minimum bettween 5 minute differernce, or something similar...)

      The reason: The camera Quality is very good, but the motion detection range is very limited... we see much longer that the PIR sensor "see" it.
      If you do that i wrote it, we able to install more PIR sensors (covered a muck bigger area) and configure a script or something similar to send a signal to Argus 2 to start recording.

      1 Reply Last reply Reply Quote 0
      • 1 / 1
      • First post
        Last post
      Reolink cloud reolink reolink Reolink cloud reolink reolink

      Reolink Store|Support|About Us|Privacy Policy|Terms and Conditions

      Copyright 2021 © Reolink All Rights Reserved.