Hello all - I just purchased a Reolink NVR RLN16-410 (4K version) and 3 PoE cameras. Today I tried the initial setup. I had all 3 cameras plugged into the PoE ports, the LAN port wired to my router and my monitor hooked up to the HDMI port on the back of the NVR and the mouse plugged into the USB. I powered the NVR up and I could tell it was running - all three PoE ports were flashing their amber lights but nothing showed up on the monitor, not even the Reolink "logo". Another thing I noticed was that no lights were lit on the LAN port on the back of the NVR. I tried everything to get a signal to the monitor, but nothing. I had another monitor that has a VGA port, so I connected that to the VGA port on the back of the NVR - nothing. Just a "no signal" message. Both these cables are good - the HDMI cable was the one supplied with the NVR. I also tested the ethernet cable from the LAN port to the router - the cable is good.

I then connected both my desktop and laptop to the network, opened up the Reolink Client and did a search for the NVR - nothing.

I have checked through the troubleshooting pages on Reolink's website but found no concrete suggestions except check cables. The cables are good - it appears to me that since I can't get a signal through either the VGA or HDMI ports and that no lights show up on the LAN port that something is wrong with the unit.

Any ideas???

Thank you
Bruce

Thank you - I appreciate the reply.

Hello all

I am considering purchasing the RLC-811A. I see that it has a siren and spotlights. Can the siren feature be disabled?

Thanks
Bruce