@joseph-chircop_497308027822318
So it didn't come back until the weekend. After I got there and resetted it, it came up fine again on my phone and let it run until this morning. Then I have installed the app on a 2nd android device, shared the connection on the first, and after scanning the code image on the 2nd it said"cannot connect to camera" and it was gone again.
Any other suggestions?

@joseph-chircop_497308027822318
After getting a third operator sim card, seems that the problems are resolved, it has been two weeks now and no problem with sharing. Thanks for the help!

@joseph-chircop_497308027822318
With this operator the connection is good, apparently.
I will do some local tests next time, also check out other sims in a good spot.
There are two aspects here I need to follow:
- signal strength : even if it disconnects, it should reconnect as most of the time the connection is fine. If it doesn't, it's a firmware issue.
- operator limitations: I don't know of any limitations in my contract other than the monthly limit for the current sim. And I don't know what to look for, but there may be some hidden ones... For the other operator I have a full 4G setup that's been online for years but, as I said, in the other location the signal is too weak for the same operator.

@joseph-chircop_497308027822318
Thanks again for the input!
This is indeed frustrating, especially because just 300m away I have a working setup with a local network connected through GSM modem, including a Reolink wifi camera. But here is too far and the signal is also weak for some operators (it's a valley below). I have tried a different sim from another operator and the signal was too weak, as it kept losing connection and blocking.
I'll probably remove the camera and take it in a better spot where I can do some sim swap and other checks.
In any case, only the connection is broken, it kept recording wild animals passing and also the battery is in good condition, despite a single possible hour of sun per day at this time of year.
But I'll have to wait two weeks for that...

@joseph-chircop_497308027822318
I could, with the risk of not being able to access it again, as I have already left the area. Why would that be relevant though? I assume the scanning is just taking the code from the picture instead of having to enteri it manually...

@joseph-chircop_497308027822318
So it didn't come back until the weekend. After I got there and resetted it, it came up fine again on my phone and let it run until this morning. Then I have installed the app on a 2nd android device, shared the connection on the first, and after scanning the code image on the 2nd it said"cannot connect to camera" and it was gone again.
Any other suggestions?

@joseph-chircop_497308027822318
Good point, thanks!
I'll check that out once (if) the camera comes back again, as it's in a remote location I don't have access to until next weekend.

@joseph-chircop_497308027822318
Thanks for the info. I have set almost the lowest quality possible. I am not sure which quality he has selected though. Today, after 12 hours I was able to connect again, worked fine for a few hours. Then he tried to connect (I wasn't connected), says it worked for 2 seconds then stopped. I haven't been able to reconnect since. We don't have windows clients (nor Windows OS), just Android phones.

Hi, I have a problem with a new Reolink Go Plus. I am supposed to share it with my neighbour in a remote location, but whenever he connects we both lose the connection for good, needs a reset to come alive again.
Anyone having this issue or knowing a fix? Otherwise it's rendering it useless...

Thanks!