I have the exact same issue. The "show alarm videos only" radio button shows up for like a second and then goes away. None of the alarm video lines that used to show up to show you where an alarm occurred are there anymore. Please either fix soon or rollback to previous version where it worked.

Any updates from the dev team about this? This feature should not be hard to code and would be incredibly useful. If you want to go back and look at all the times motion detection was triggered to view the video around it then there is currently no way to do that. Again, I am a software engineer and would donate my time to get this done.

Thanks,

-- Joshua

Bob,

Thanks for forwarding my request to the dev team. once again, I offer my development abilities to code this myself and submit a patch to your dev team to get this done quicker, along with the other requests I have made. Can you please check with the dev team to see if this is possible?

Thanks

Bob, the cameras report what mode they are in, be it black and white or color. All the system needs to do, is detect when the cameras are switching from black and white to color and vice versa, and just not report movement during that transition, which would be a single frame. This wouldn't be a security issue seeing as how it's only a single frame. I don't feel I should have to work around system limitations by changing the sensitivity levels. I still feel this needs to be added as a feature.

Thanks

Every morning I get an alarm when my cameras switch from black and white to color mode because the sun is coming up. This should not be the case. I don't need an extra alarm to wake up in the morning!

Thanks,

-- Joshua

Any update on if they will send me the code and allow me to make a patch?

Thanks,

-- Joshua

Thank you for your reply. Is there any chance of getting a copy of the source code for the NVR, implementing this feature myself, creating a patch, and submitting it back to the Reolink devs? I am a software developer and wouldn't mind contributing, for free, to the cause to get this implemented quicker.

Thanks,

-- Jworrin

I would beg to differ that it is always network connection issue. When connected to the same wired connection the settings don't always load for me. When that happens, I must close and open the application a few times sometimes to get them to load. Everything else will work flawlessly, to include live streaming and playback. If it were a network connection issue, then those wouldn't happen.

I would like the ability to look at all the alarms that have been set off. Currently I have 8 cameras recording 24hrs a day, so I can't just go look at where they recorded because of an alarm, because they are always recording. Adding an alarm tracker that says when an alarm went off on which camera would be nice.