Correction, the hardware was H3MB18, apologies.

Hi Everyone,

I purchased a security system from Amazon RLK8-810B2D2-A. The NVR is a RLN8-410 and the hardware version is HBMB18. The firmware version was old so I navigated to the Reolink website and grabbed the firmware V3.0.0.118 as this said it was specific to my NVR.

I followed the steps and the update was successful, however, my NVR will no longer load. When turning on it simply just freezes at the Reolink logo and does not go any further. I have not upgraded the camera firmwares yet as I've not been able to get that far and now the system won't even initiate I'm at a point where I'm stuck,

any help would be greatly appreciated,

Thanks,

Keith.