Posts made by lee_533172240990388

Hi, Ive recently purchased 2 x Reolink Go PT cameras.

The first camera i setup as per the instructions, i had no issues and its up doing its thing.
The second camera , after i scan the code for some reason isnt able to proceed to the next steps to connect to the Wifi network.

When i click "no, i didn't hear the audio" it recommends to factory reset the camera.

I tried factory resetting the camera but no matter how long i hold the pin in, there is no audio message so say factory reset.

Is this a DOA? Is there anything i should try before returning is?

Thanks

Sorry, another question for Time Lapse.... Is there any way to check the time lapse progress without stopping it? If i was to stop it to check its working correctly, when i start it again will it automatically add to the original video or do i need to stitch the two together?

Thanks

Hi all,

Ive recently purchased the Reolink Go Plus 4G.
Its setup over looking a construction and i plan to run a time lapse for 365 days.
Ive installed a 128GB memory card.

The builder was asking if i could also enable recordings for motion detection. As there will be a lot of motion on site I'm assuming the memory card would fill up quickly and need to overwrite its recordings.
My question is, if i was to enable recording how would this affect the time lapse? Does the time lapse allocate sufficient amount of space for the duration of 365 days?

Thanks

Hi all,

Ive just received my GO Plus 4G and intend to use it for time-lapse capture of a house being built.
The construction will take 12 months and i planned on taking as photo at 9am and 2pm every day for 356 days

Ive gone through the time-lapse settings but am still a bit confused.
Can anyone help advise what settings i need to use in the app?

Also is it possible to share the camera with another person but give them read only access so they cant mess up the settings.

Thanks

My original intention was to obtain the Reolink Go as i wanted to run a time lapse for the duration of the build.

Q. If i purchase the ReoLink Go PT version and configure the Time lapse settings, what happens if manoeuvre the camera to a different angle? Does the camera just take a photo of that location at the time specified or is it possible so that the camera returns automatically to the original position of the timelapse before it takes the next photo?

Thanks