Reolink updates Learn More
Meet Reolink at IFA 2024! Learn More
Reolink Q&A Learn More
Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.
Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).
Previously I had an installation of a RLN16 and 9 cameras with 24/7 recording, and while very happy with the actual recording quality, playback (via the Reolink Windows application or Android app) left a lot to be desired. Seeking in the timeline was painfully slow, and massively worse when trying to view multiple cameras (for example when tracking the movements of a person across the site), it even often failed to playback with four cameras up on the fluent setting.I've recently built out on a new site, with a bigger installation (2x RLN8 1x RLN16 with four cameras per system), and on a whim decided that I would opt for multiple smaller systems in the hopes that the above limitation was disk speed / seek times. It seems I was (at least in part) correct, as seeking on a system only recording four cameras is significantly better, and the fact that when viewing multiple cameras they're often split across NVR's has also helped immensely.Would adding a second hard drive to each system help performance further?I'm adding six more cameras in total, and am likely to add few more cameras before I'm done, and am trying to weigh the cost savings of putting more cameras on each NVR vs the benefits of adding another NVR to the mix.
Is there a way to remove a camera from an nvr?I have 4x nvr's deployed in a location (3x 8ch, 1x 16ch), recording 35 cameras.One of the camera's is connected to the network instead of the nvr directly (just due to location, a direct connection was not a possibility)This has worked well for quite a long time (>2 years), as the camera was adopted by one of the nvr's and allowed recording from the system.Yesterday I replaced a failed rln8-410 (after approx 4 years of service), and immediately all of the cameras that were attached to to it were recognized and setup again, BUTThat one floating camera is now being seen by three of the NVR's, and two of the three seem to be fighting for control (my email is filled with the two systems alternately complaining about video loss for that camera for the last 16 hours).I've managed to disable the alarm emails for those channels (a process that is extremely unintuitive if the channel is offline, requires using the copy-to function from a working camera channel).I don't have a lot of faith that it won't randomly stop recording on the intended nvr (due to conflict with the other two units vying for control), so it would be better to not have the camera not show multiple times in the first place. This will surely also confuse the couple of users on the systems if they see the camera in multiple fields.
Welcome Back!
Hi there! Join the Commnunity to get all the latest news, tips and more!