I properly disposed of the camera already, so no further action is required!

There is one thing about Reolink: Their software department really sucks. They need a kick in the b.., and get things going.
I contacted them about 8 months before the Flash deadline and they assured me it is already in the works.
I than found a firmware update for my camera, downloaded it, updated the camera ---- and then............BRICK!

We need the HTML5 now!
Every software needs some debug time. If you release the HTML5
support by end of year, we will be doomed!
It takes at least 6 Months to get all the bugs out of the system.
I did not buy several cameras to be stuck by end of 2020 and
start all over again!

PLEASE PUBLISH A RELEASE DATE TO SHOW YOUR COMMITMENT

I have a dumb question:
How do you assign a channel to a WS type camera, or a camera that is not directly plugged into the LAN port of the NVR?
I have two RLC-423 cameras (one is a wireless WS), and i have but cameras shown plus two ghost cameras as channel 1 + 2.
For the actual cameras the channel selection is grayed out.

The RLC-423 is a high res camera, that is why I bought it. If I want to send a picture to wunderground.com it gets rejected because it is too large (max=150kb).
I can set the camera to a lower res and make it work, but that would leave me with a low res recording too.
I wonder if there is a way to get a snap from the Fluent stream, rather than from the CLEAR stream.

I can get both to work, but the problem is that the picture size cannot be more than 150kb.
So, I have to set the camera to a very low resolution. I don’t want to do that because I am recording
in HIGH resolution so that I can see detail.
I would be great if I could tell the URL what stream to use CLEAR or FLUENT, most webcams have that feature.
Then I set fluent to low res and clear to high res.

Like that:
http://xxxxxx.dyndns.org:8888/cgi-bin/api.cgi?cmd=Snap&channel=0&stream=fluent&rs=FrontCam&user=action&password=xxxxxx
or like other cameras allow:
http://xxxxxx.dyndns.org:8888/cgi-bin/api.cgi?cmd=Snap&channel=1or2or 3……&rs=FrontCam&user=action&password=xxxxxx

Please let me know if anyone has the API.CGI command manual so that I can possibly find the correct syntax myself.

I just (2 weeks ago) got 2 Reolink RLC423 and a Reolink NVR.
I have to say that the Reolink Client software is one of the worst things I have ever seen.
I have the cams working, I get alarms, but I cannot figure out how to use the nvr via the web.
FireFox and Chrome are not working with the webclient, but internet explorer seems to work.