Posts made by travis_80748582678681

I didn't get a chance to try it out yet, camera project has been paused for the winter. Let me know if it works out for you, otherwise I'll post again when I get back around to it.

I understand it is not advised to do so (not worried about warranty), I just need to know if I can rewire the camera using the aforementioned wiring and get it to work. I don't have the option to use your junction box.

Hello,
I've been setting up these cameras at a business and I've run into an issue where I need to cut the camera cable itself. A few of the cameras are going to be mounted outside and I need to run the cables into a gang box, but unfortunately due to the size of the cable split and the RJ45 connection, I'm unable to use cord grips. Is it possible to clip this cable past the split and terminate into another female RJ45? I found the following wiring information on the Reolink site that I wanted to double check:
Pin 1 - orange & white
Pin 2 - orange
Pin 3 - green & white
Pin 4/5 - grey
Pin 6 - green
Pin 7/8 - Purple
1498783277.png