@user_591792059080827_591792059080827
False alarms in an outdoor camera can be caused by a number of factors, including moving objects, lighting changes, and even bugs or animals. Here are some steps you can try to fix the issue:

1. Check the camera's position: Make sure that the camera is not pointed at a busy street or an area with frequent passing vehicles. If it is, consider relocating the camera to a different spot.
2. Adjust motion detection settings: You can try adjusting the motion detection sensitivity settings. If the sensitivity is set too high, even small movements, such as leaves blowing in the wind, can trigger false alarms. You can also adjust the motion detection area, so that it only covers the necessary area.
3. Update camera firmware: Check if there's a firmware update available for your camera and install it if there is. This can sometimes fix bugs and improve the camera's performance.
4. Check for environmental factors: Environmental factors, such as bright lights, reflections, and moving branches, can also trigger false alarms. Try repositioning the camera or covering windows and lights in the area to reduce reflections.
5. Clean the camera lens: Dirt, debris, and bugs can accumulate on the camera lens and cause false alarms. Clean the lens with a soft cloth and make sure it's free of any obstructions.

If none of these steps solve the issue, it may be necessary to contact the manufacturer for further assistance or consider a different camera.

@dgordon42_415060065599711
I am also having a same bug.

@joseph-chircop_497308027822318
If you want to connect the NVR to your router via WiFi, please go to the NVR WiFi Setting page, then select the "Station" mode. After that, you may connect the NVR to your router's wifi. And the SSID and Password (Station mode) in the picture below will be your router's WIFI SSID/Password.