RLC-810A POE - network cable pairing after plug got ripped off

[vogel_284858079064306]

The RJ45 plug from my RLC-810A camera got accidently ripped off and so did the plug from the CAT6 network cable. I am trying to connect the two cables with an CAT6/CAT7 LSA patch connector but I can't figure out how to pair the cables correctly.

CAT6 Ethernet:
orange
orange-white
blue
blue-white
green
green-white
brown
brown-white

RLC-810A
orange
orange-white
green
green-white
purple
grey

I tried to match orange and green and connect purple and grey to the blue / blue-white cables but it didn't work out. Can anybody give me a hint?

[joseph_1979]

@vogel_284858079064306 check this out https://www.reddit.com/r/reolinkcam/comments/kn53d0/network_cable_wiring_question/

[vogel_284858079064306]

@joseph_1979 Thank you!

In the meantime I found an corresponding article here: https://support.reolink.com/hc/en-us/articles/900000605206-Introduction-to-Ethernet-Cable/