Researching how to have WIFI camera inside metal buiulding

[gkl_293453548720263]

I was wondering if anyone has tried this or if there is an antenna cable to extend the camera's WIFI antenna to the outside of a metal building while having the camera inside the building ?

(I would also have the solar panel outside the building obviously, there would be no electrical connection to the building)
(The metal building would be too far from the house to run a wire for a wired connection.)

[joseph_1979]

@gkl_293453548720263 See if this helps you https://support.reolink.com/hc/en-us/articles/26862588584089-Introduction-to-Antenna-Extension-Cable/

[gkl_293453548720263]

@joseph_1979 Thanks, I ordered one from Amazon, now I am trying to research how thick the cable is so I can know what size rubber grommet I need to get so it will be a watertight seal when going thru the wall of the metal building, not a big deal though as I can wait to receive it to measure it in person, I just like to plan ahead

[joseph_1979]

@gkl_293453548720263 For sure you need to make a hole with diameter 7.67mm to allow the sma rp connector to get through. Use silicon.

You were on Reddit too....there are lots of members