Reolink updates Learn More
Meet Reolink at IFA 2024! Learn More
Reolink Q&A Learn More
Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.
Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).
I have had a couple of cameras fail recently though a power cycle. They are out of warranty so I have removed the outer cases to check the internal wires etc. I have found that both back-batteries on the main pcb are 0V. I have replaced these, but the cameras refuse to be detected, both before and after a factory reset. Is there a sequence to follow to re-initialise the pcb?
Welcome Back!
Hi there! Join the Commnunity to get all the latest news, tips and more!