@christian Yes, after manual calibration it goes back to its correct gard point which it is set to, if it could be set to automatically do it every day it could be nice but probably an emergency solution.
I don't know if this applies to the whole E1 series, my wifi 5 mp hasn't done it yet but it doesn't move very much either as it has a wall on the right side and another E1 8 mp PTZ I have which also doesn't move much is it also more rarely, so it must become imprecise when it has followed people and animals a certain number of times, quite strange because it probably stores the image of the guard point and steers back according to the image, one would think, but maybe it is what degrees guard point is set at it tries to go back to and so there is some inaccuracy every time, mysterious because here it is sometimes just a few degrees off, other times it turns away completely and points towards the wall in the exact opposite direction off guard point

@christian Yes, after manual calibration it goes back to its correct gard point which it is set to, if it could be set to automatically do it every day it could be nice but probably an emergency solution.
I don't know if this applies to the whole E1 series, my wifi 5 mp hasn't done it yet but it doesn't move very much either as it has a wall on the right side and another E1 8 mp PTZ I have which also doesn't move much is it also more rarely, so it must become imprecise when it has followed people and animals a certain number of times, quite strange because it probably stores the image of the guard point and steers back according to the image, one would think, but maybe it is what degrees guard point is set at it tries to go back to and so there is some inaccuracy every time, mysterious because here it is sometimes just a few degrees off, other times it turns away completely and points towards the wall in the exact opposite direction off guard point

@reolink-lorenz thanks for feedback, I have done and tried your support's various suggestions, it goes out of gard point now after a few days on the one that records the most traffic, the other one where there are rare recordings it takes a longer time between it goes out of gard point, the only solution I need to try before RMA is a total reset on the camera, I haven't had time for that yet, but I don't have much hope that it will help either, because it has done it since the beginning when I got it/them

Is there anyone in this thread who has tried resetting the camera which has solved the problem ?

I am having the same issue on my 2 E1 outdoor 8mp POE Firm. 3.1.0.1856_23030800 got the E1 wifi 5 mp to but this one dont have the guard isue but it also has limited visibility

Every time i use snapshot form my pc with Windows 10 updated Reolink app freezes and won’t answer and I have to shut down the app, all my other 5mp E1 works fine sawing to same location on my pc .
My cam is REOLINK RLC-822A 8mp  v 8.10.4

@reolink-fiona
Ok thanks I will do so then, buy from reolink.com. I can see that you send the item from Germany, so there should be no extra customs or charges to Denmark

@reolink-fiona
Thanks for reply. but unfortunately I still do not know which version I should buy for the companies do not state hardware number on Reolink RLN8-410 (v2)
or other Reolink RLN8-410 models.
I have asked in their support department and they do not know hardware number either on Reolink RLN8-410(v2) 8-channels | Dustinhome.dk
So it's going to be a bit of a buy in blind and just hoping it's a model with AI.

Anyone know if NVR RLN8-410 (v2) has support for person and vehicle recognition, I found it difficult to see when there are multiple models of NVR RLN8-410 and it is hardware version that determines AI support