FE-P Fisheye camera not ONVIF compliant
-
I just purchased the panoramic fisheye model as it was advertised as being ONVIF compliant. I also have two Reolink E1 Pro cameras that are ONVIF compliant so I had no concerns when buying the FE-P.
However... while my Luxriot NVR can connect to the FE-P and stream video just fine, as soon as the camera detect movement instead of signaling the movement to the NVR, it causes the video to *not* being recorded by the NVR. Whenever this happens, I can still view the video just fine using the Reolink apps, it's just that there seems to be an issue with ONVIF.
The camera is running firmware v3.0.0.1901_23032202, and when doing a check for new firmware, the camera reports it's runnign the latest.
HOWEVER...
When checking the official onvif website www[.]onvif[.]org/conformant-products to see if the camera is indeed certified... it turns out that the certification only applies to a new firmware (v3.0.0.1987_23041503) that is not publicly available.
Can reolink please make that firmware available to see if it resolves the issue with the detection causing the NVR to stop recording? The FE-P model does not even appear in the list of available cameras on the firmware download page... -
I have the EXACT same problem.
Reolink sells the FE-P camera on their website. But there is no model listet in the download center section. Auto-Update and manual update inside the reolink app says, that the firmware is the newest.
But it is obviously not! -
Now ONVIF Page says "v3.0.0.3256_2405131415" is the newest firmware for the FE-P ???
What's up Reolink???