Motion Detection Push Notifications Improvement Suggestions

FongJeng Kum

Ok, that sounds reasonable and easily implemented, I would say.
Or can I just add, also allow options to set the disabling for a period of time, say, 1 hours, 2 hours, or until I manually turn it back on.

I would provide both. The ability to turn off motion detection until it is re-enabled and the ability to set a timer to re-enable. If I had to prioritize I would provide the disable option first and let the user be responsible for re-enabling it.

Bob

Thank you guys for your brilliant ideas. I will put in your requests.
For RLC-410S, it has pre-record when recording to its on-board microSD card. The option for pre-record is under Device Settings >> Recording >> Option. And there is another option there for post-record: 15s, 30s, 1min.

For RLC-420 or other cameras with no microSD card, it will also have pre-record if you manually record to PC or FTP upload to server. But the pre-record is significantly shorter. And you have the post-record option if you check client local settings >> Record Settings, which is for local recording to your PC hard drive.

FongJeng Kum

Hi Bob,

From my RLC-410S, I don't see this option "Device Settings >> Recording >> Option" to set Pre-Record.

Selection_033.jpg

Tom Scheifler

Kudos for considering and actually doing some of the requests in this thread. Here's another ...
Please turn off push notifications when I pan/tilt/zoom the camera. It makes no sense to send a motion notification caused by PTZ.

Thanks,
Tom

Alfalfa

hello, do we have any updates to this? it's been a long while and i still only see "Alarms From IP Camera" on my notification and NOT the specific cam which the alarm was triggered from.

Alfalfa

thank you for the push notification update; now we see the specific camera names instead of generic "IP Camera". this was a big help giving us a good preview of which camera triggered by motion or otherwise.

thanks again Reolink!