Introducing Our New Forum and New Mods to You
NVR New Firmware with Pet Detection
5MP PoE/Wifi Smart Doorbell Pre-Order Starts! Hurry up to Buy!
New Client with Time-Lapse Function and Hardware Decoding
Duo 2 Tips: Recommended Installation Scenarios & Settings
Hello all , I need some help , it seems every time I have a power failure the cameras loose all their setting including Wifi . These cameras are IP RLC - 410Very annoying as I have to set everything all over again . Any help please !!!
Hi David, Not sure what's wrong with the device, I've got 410's and they're ok for me. I'm sure that once you're making changes you're saving the changes to flash afterwards? You could save and export the config so if it loses all the config importing the saved config back in will reduce the amount of effort to restore the camera to its preferred settings.Config > system > maintenance > configuration import / export Hope that helps..
Hi David,Apologies, just read your post again and you have stated that Wi-Fi is gone as well so you wouldn't be able to use my suggestion but if you save the config file once you've restored Wi-Fi settings you should be able to import the camera config file.. (I think?) Cheers
Hello , many thanks for taking time to get back to me , really appreciate . I'm not sure if the RLC-410 has an internal battery cmos type battery that has failed . It seems that every time we have a local power failure which is very common here in Malta , both cameras loose all the setting .Yes have used the configure file to get back the data but each time I have to dismount the cameras from their position to connect hard wired to the network to get it back to work . Like doing a new setup . But than all is lost once power supply fails .Quite a disappointment as I have also bought additional cameras which I have installed at other friends places , but no issue with those so far but than maybe because they are newer .I remember for the first months they worked fine even after a power failure .Thanks David .
Hi David,Please upgrade (or downgrade) the firmware of the camera as to reload the firmware. And tick "Update config file" to make sure the settings are restored. If the issue persists after this, then we can say the battery inside the camera is dead and unable to save settings after power loss.Thank you.
Can I know if the battery is replaceable?
Normally, the battery can sustain for years. If it drains out, the camera needs to be replaced and sent back to our factory for repair.
Hi Bob,Thanks for letting know.
Bob , thanks for your information , the problem is that I bought these cameras are last december, so 10 mths old , I didnt expect this to happen.
Hi there! Join the Commnunity to get all the latest news, tips and more!