Anonymous last edited by
Hello! A couple of (hopefully simple) improvement ideas!
For the RLC-410 at least, choosing 1080P results in output streams as follows (as reported by ffmpeg):
Stream #0:0: Video: h264 (High) ( / 0x0007), yuv420p(progressive), 1920x1072, q=2-31, 30 tbr, 1k tbn, 90k tbc
Stream #0:1: Audio: aac (LC) ( / 0x000A), 16000 Hz, mono, fltp
Directly streaming this to YouTube results in two compaints: 1920x1072 is smaller than 1920x1080, so YouTube complains that it is not a standard resolution and only allows 720p or smaller to be selected for viewing; and, 16kHz audio is less than the recommended 44.1/48kHz. Could either of these be standardized?
FongJeng Kum last edited by
Definitely something REOLINK needs to look into.
Hope they will standardize it.
Bob last edited by
Your request has been collected. Engineering is reviewing the feasibility of implementing this idea. We’ll schedule to implement the request if it’s accepted. Otherwise it goes to the suggestion pool and may be reactivated if others make similar requests again. Thank you sincerely for sharing your thoughts. We will take your request seriously and work hard to make our products better~