Don't detect switching between day/night mode as movement and recording it

[MagnusT]

Twice a day, every day, on each camera I get movement detection and (not very useful) video recordings of when each camera switches between day and night mode.

It would be nice if it simply ignored any "movement" during a second or two when it knows it is itself doing the mode switching. Just let the code that switches the mode "turn off" the movement detection (if its on) right before it switches mode, then wait one or two seconds and turn it back on if it was on.

What do you think?

[joseph chircop_497308027822318]

@magnust This has been solved through the introduction of the alarm delay. Not all cameras have this feature. For sure this is not on battery powered cams.

[MagnusT]

@joseph-chircop_497308027822318


There is alarm delay for people and vehicle detection on my RLC-510A cameras but not for movement what I can find?

[Crimp On_62210811129]

OMG - Yes. Have been frustrated by this phenomenon for YEARS.

[quizzical]

I would also be very interested in solving this. There is indeed a delay feature for 'person detection' but that one is not falsely triggered by day/night mode.
It is the motion detection feature that is falsely triggered.