Introducing Our New Forum and New Mods to You
NVR New Firmware with Pet Detection
5MP PoE/Wifi Smart Doorbell Pre-Order Starts! Hurry up to Buy!
New Client with Time-Lapse Function and Hardware Decoding
Duo 2 Tips: Recommended Installation Scenarios & Settings
Hi everyone,I have a prob with my Argus2 which I want to use at my home now.It was installed at another WLAN but connection was not possible for some days, so I decided to take the camera to my place, charge the battery and setup the camera with my WLAN at home.I get a green light at the battery which shows it is fully loaded but when I try to connect to the camera after I scanned the QR code of the cam nothing happens. Even pushing the reset button does not make the camera talk at all.I wonder if the camera is dead and needs to be replaced.I only have one battery, so I cannot try another battery on the camera.Should the camera make any sound when the battery is connected? Should there be a led lit on the front when I insert the full battery?I only have one Argus2, so I have no chance to compare the behavior with a working camera.Thanx a lot for your help. I also contacted support alredy but did not get a reply yet.Dee
Hi Ricky, please refer to Learning the working mode and the LED status on the Reolink Argus/Argus Pro/Argus 2 to check the working status.
Hi Carl,thank you very much for your reply and your suggestion.As usual I was looking for the problem on my side, but in this case the camera was defective. It stopped working without any change of network or setup just by itself. I took the camera home to test it, but it had an intermittend occuring problem.I received a replacement which is working fine.Best greetingsDee
Hi there! Join the Commnunity to get all the latest news, tips and more!