Posts made by Bill1426

Yes, I will not get a notification (or a delayed notification) from a camera that the detection zone(s), have been randomly modified.
Once, I clear the detection zone, the notification(s) work are quick.

Here is another FYI, If I see the detection zone has a modification, I will look again later and the modification is gone.
Then randomly it will return (sometimes the same zone markings, other times different zone markings)..

I have noticed that if there is a marked zone to not be detected, then most of the time (but not all the time)there will not be a modification. But, if the detection zone has No marked zones (totally clear), then modifications happen randomly.

Currently I do not have a monitor connected to the NVR..
I will check to see if & when the glitch happens again, and then connect a monitor to see if the issue is present at the NVR.

An update to this issue..
I waited a few days, and looked at the Motion Detection Zones via the Web Browser.
And I see that the issue is also seen via the web browser.
So this looks like a firmware issue, not a Windows Client issue.

Most cell phones and apps allow you to use the Finger Print Scanner (biometrics) as a way to access
an app, rather than entering the app password..
I would like to see that implemented in the Reolink app for cell phones.

Email Sent

I found that in the Windows App the Motion Detection Zone changes randomly.
Some cameras are fine, and others change. Then you look back at the ones that were fine, and now they changed.
I noticed it more so, when Stretch mode is enabled.
It doesn't happen in the web connection, only in Windows App.
Pictures attached.
---------------------------------
Windows 10 Home (build 19042.964)
Reolink Windows App: v8.2.6
---------------------------------
NVR: RLN8-410
Build: 2103125
Hardware: N2MB02
Firmware: v3.0.0.123_21031205
Garage-Door-quirk.jpg
Garage-Door-proper.jpg

Can we add Finger Print Security, or a PIN rather than entering a password every time you open the app ?
RLN8-410